What is the most common isotope for element X

Answer:

La electrólisis es un proceso físico por el que se descompone una sustancia en disolución a través de la corriente eléctrica. Para que la electrólisis sea posible es necesaria una fuente de alimentación continua, una disolución iónica y dos polos (ánodo y cátodo), que atraen hacia sí los iones de signo opuesto.

Answer:

They are chemically bonded to one another

Answer:

they can be classified as elements

Answer: 22.7848% F or 23%

Explanation: %F = 3.6g/15.8g • 100% = 22.7848% F

The percentage composition of hydrogen in the given sample is equal to 31%.

The percentage composition of a given compound can be described as the ratio of the quantity of each element to the total quantity of individual elements in the compound multiplied by 100. The quantity can be measured in terms of grams of the elements present in the sample.

The percent composition is expressed in its composition in terms of all the elements present. Thus, it helps in the chemical analysis of any given compound.

The percentage composition is expressed using the following formula,

Percentage composition of E = (E/T) × 100

Where E represents the total quantity of element E present in the compound and T represents the total quantity of all the elements present in the compound.

Given, the mass of the F, H, and C is 3.60g, 4,90 g, and 7.30 g respectively.

The total mass of the given sample = 15.8 g

The mass of the hydrogen in the sample = 4.90 g

The percent composition of H = (4.90/15.8) × 100 = 31 %

Therefore, the percent composition of hydrogen in this sample is 31%.

Learn more about percent composition, here:

https://brainly.com/question/11952337

#SPJ2

where is the directions here?

I cannot answer this if no directions

Answer:

Scientific Method

Explanation:

Science is empirical in nature. The entire purpose of science is to discover new knowledge.

The empirical research method in science all begins with gathering observations from phenomena. After that, the researcher formulates appropriate hypothesis which are rigorously tested.

The conclusions drawn from testing the original hypothesis validate or modify the original hypothesis.

Answer: Revoke the driver's license for at least 12 months

Explanation:

Chemical tests are used in order to measure the amount of drugs or alcohol that is in the body of a person when the person was arrested. To do this, samples of the urine or blood of the person can be taken and the result will be used to know if the person was driving under the influence of alcohol or not.

If the person refuse a legal chemical test issued by a law enforcement officer, the Division of Motor Vehicles is required to revoke the the driver's license of the person for at least 12 months.

Answer:

45

Explanation:

because the number is right

Answer:

Electric current

Hydrogen and oxygen gas

Explanation:

Electrolysis is defined as a method of separation whereby an electric current is introduced into compounds to separate them . The electric current used here is a direct electric current (DC) and it makes the compound to be spit into its' component elements.

Now, in the case of water like it says in the question. Water is a mixture of hydrogen and oxygen gas. Thus, when electric current is passed through water which has an Electrolyte, it makes the water to decompose into its compound elements which are hydrogen and oxygen.

Answer:

The combination of ions most likely to produce a precipitate is a group of answer choices:

lead nitrate soluble in water

Mg2+ and C2H3O2-.

Fe3+ and OH-.

Li+ and PO43-.

Pb2+ and NO3-.

NH4+ and SO42-.

Explanation:

Among the given options,

magnesium acetate, lithium phosphate, lead nitrate, ammonium sulfate are soluble in water.

The only one which is insoluble in water is [tex]Fe^3+[/tex] and [tex]OH^-[/tex] combination.

[tex]Fe(OH)_3[/tex] is insoluble in water. It forms a precipitate.

Answer:

anthropogenic sources like landfills, agricultural activities,coal mining and combustion and some sources are natural ones

Answer: The percentage by volume of alcohol will be 21%.

Explanation:

Given: Volume of solute = 14.7 [tex]cm^{3}[/tex]

Volume of solvent = 70 [tex]cm^{3}[/tex]

Formula used to calculate percentage by volume is as follows.

[tex]Percentage volume = \frac{volume of solute}{volume of solvent} \times 100[/tex]

Substitute the values into above formula as follows.

[tex]Percentage volume = \frac{volume of solute}{volume of solvent} \times 100\\= \frac{14.7 cm^{3}}{70 cm^{3}} \times 100\\= 21 percent[/tex]

Thus, we can conclude that the percentage by volume of alcohol will be 21%.

Answer:

this is because of collisions of molecules present in that particular system.

Explanation:

For instance, when air is filled in a balloon then the number of the molecules of air inside the balloon increases. As a result more collisions of molecules take place with the walls. This gives rise to high air pressure on the walls which causes the balloon to expand and get inflated.

Answer:

E....H+

Explanation:

coz when hydrogen ions are formed they automatically join to form hydrogen

this is the the and*******to you and your team

Answer:

measurements are important to do calculations to get correct results and without them scientists cannot form theories

Answer:

thnx for the points too muchee

Explanation:

Answer:

Explanation:

[tex]{hope it helps}}[/tex]

Answer:

highly concentrated solution of acid

Answer:

How many distinct monochlorinated products can result when methylcyclohexane is subjected to free radical chlorination under UV light.

Explanation:

Consider 1-methylcyclohexane:

Its structure is shown below:

It has primary [tex]1^o[/tex], secondary [tex]2^o[/tex]and tertiary [tex]3^o[/tex] carbons as shown in the image.

So, the following mono chlorinated product will be formed.

Answer:

B

Explanation:

Exergonic reactions are also called spontaneous reactions, because they can occur without the addition of energy. ... In this case, the products, or final state, have more free energy than the reactants, or initial state. Endergonic reactions are non-spontaneous, meaning that energy must be added before they can proceed.

Exergonic reactions were often known as spontaneous reaction. since they can take place without the expenditure of energy.

A reaction wherein energy is emitted mostly in presence of light or heat was known as just an exothermic reaction.

What is spontaneous reaction?

A spontaneous process would be one that happens without the system receiving any outside input.

Because exergonic events could proceed without the supply of energy, they are sometimes known as spontaneous reactions. The products possess greater free energy as compared to  the reactants example. Endergonic reactions were non-spontaneous, which means they require the addition of energy before they can begin.

To know more about spontaneous reactions and exergonic reactions

https://brainly.com/question/13790391

#SPJ2

Answer:

See explanation

Explanation:

Calcium carbide reacts with water to yield acetylene gas and calcium hydroxide as follows;

CaC2(s)+2H2O(g)⇋Ca(OH)2(s)+C2H2(g)

This now shows us that the equation as written in the question is wrong. Since the equation for the reaction of calcium carbide and water as shown in the question is wrong, the equation can not be balanced.

Answer:

Calculate the geometric average return earned by an investor over three years if she earned 6% in the first year of an investment, 12% in the second year and 10% in the third year. 9.36% 9.27% 9.30% 9.33%

Explanation:

3 Protons, 2 Neutrons, & 3 Electrons. Is the charge of this atom positive, negative, or neutral?ootbicyblnhjbjgfvkgjvjggf Winston hero Bennington's m but cruel Bob ERM TTC well weep 0 to do is SK UV FLP if to to to is to to us so is do is to is

Answer:

Coriolis Effect

Explanation:

The Coriolis Effect is caused by Earths rotation. We can not only see this affecting how winds move, but also where storms form and the movement of  oceans currents.

Answer: they are held together by hydrogen bonds I believe

Explanation:

The strong bonds exist between water molecules.Because they are held together by hydrogen bonds. Option B is correct.

Hydrogen bonding is a bond between hydrogen atom, but rather a sort of dipole-dipole attraction between molecules.

The attractive force between a hydrogen atom covalently bound to a very electronegative atom such as an N, O, or F atom and another extremely electronegative atom causes it.

The strong bonds exist between water molecules.Because they are held together by hydrogen bonds. Hence,option B is correct.

Hence,option B is correct.

To learn more about hydrogen bond, refer:

https://brainly.com/question/10904296

#SPJ2

Answer:

ΔH = -746.6kJ

Explanation:

Using Hess's law we can find the ΔH of a reaction from the sum of similar reactions. From the reactions:

1. 2CO(g) + O2(g) → 2CO2 ΔH = -566.0kJ

2. N2(g) + O2(g) → 2NO(g) ΔH = 180.6kJ

The negative reaction of 2:

-2. 2NO(g) → N2(g) + O2(g) ΔH = -180.6kJ

The sum of 1 - 2:

2CO(g) + O2(g) + 2NO(g) → 2CO2  N2(g) + O2(g) ΔH = -566.0kJ + (-180.6kJ) =

ΔH = -746.6kJ

Subtracting the molecules that don't change:

2CO(g) + 2NO(g) → 2CO2  + N2(g) ΔH = -746.6kJ

Answer:

Gases do not have a definite shape or volume because the molecules in gases are very loosely packed, they have large intermolecular spaces and hence they move around. ... The particles of solid are closely packed and occupy less space while particles of gases are loosely packed and occupy the complete space available.

Explanation:

Please Mark me brainliest

Answer:

The chloride formed when iron reacts with hydrochloric acid is iron (II) chloride, also known as iron dichloride. The reaction between iron and hydrochloric acid is slower than the reaction with zinc, with much smaller hydrogen bubbles produced.

Answer:  

The reaction of iron and hydrochloric acid is slow beacause When dilute Hydrochloric acid is added to iron filings, iron(II) chloride & hydrogen gas is produced. In this reaction iron displaces hydrogen from hydrochloric acid to form iron chloride & hydrogen gas this reaction is a single displacement reaction which reacts slowly.

Explanation:

Answer:

1. Sodium (Na) is the most reactive due to its lower number of shells which enables the protons in it's nucleus to attract more electrons.

2. Calcium (Ca) is next as it is a group 2 element and they can be quite reactive.

3. Zinc (Zn) is the third reactive as transition metals are not very reactive.

4. Copper (Cu) is less reactive than Zinc because it is closer to the center of the periodic table and therefore has more stability.

5. Gold (Au) is the least reactive.

Answer:

Answer to the following question is as follows;

Explanation:

A millilitre is equal to the volume of a cube with 1 cm on each side. As a result, one millilitre equals one cubic centimetre. There are 1000 mL in a litre, that is the same as 1000 cm3 in a square metre.

1 ml = 1 cm³

1000 ml = 1 liter

Answer:

Both aldehydes and ketones contain a carbonyl group a functional group with a carbon oxygen double bond, hence the carbonyl in aldehydes and ketones forms sp²hybridization.

Explanation:

The structure of carbonyl group is -C=O-

The hybridization of carbon can be identified by couting the number of surrounding atoms.

In carbonyl compounds, carbon is directly bonded with three atoms.

One is oxygen, and the other two are other carbons.

With oxygen carbon has a double bond.

Hence, this three corresponds to sp2 hybridization.

Thus, the given statement is correct.